Technicians Will Perform the Following Checks:

• Clean air filter
• Wash I/D coil (extensive cleaning extra)
• Check and flush condensate drains (must have cleanout Tee - extra task to install)
• Flush condensate pan
• Clean and flush condensate pump if applicable
• Check aux. pan for cracks or bad seals
• Do visual check of ductwork for leaks or deterioration
• Wash O/D coil if needed (extensive cleaning extra)
• Tighten electrical connections
• Check incoming voltage
• Check amp draw of compressor
• Check amp draw of indoor fan motor
• Check amp draw of outdoor fan motor
• Check for loose or frayed wires
• Inspect contactor points
• Inspect capacitors for leakage
• Take sensor readings if applicable

• Replace missing armor flex insulation up to 12” at no charge
• Make sure outdoor unit is raised if it's a heat pump - (minimum 4” above pad)
• Lubricate motor
• Check blower wheel (extensive cleaning extra if removal required)
• Check for proper airflow - CFM
• Check refrigerant pressures
• Check superheat readings
• Check sub-cooling readings
• Take temperature readings (dry bulb)
• Take temperature readings (wet bulb)
• Check thermostat calibration
• Check piping for possible rub-through
• Make recommendations to customer in writing

Our Technicians Will Perform the Following Checks:

Gas Boilers:

• Tighten electrical connections
• Check wiring
• Check incoming voltage
• Check transformers
• Check amp draw of inducer motor
• Check amp draw of circulator
• Check intake and exhaust vents
• Check boiler limits and safety controls
• Check aqua stat
• Check and clear condensate drains and trap
• Check all pressure switches
• Check igniter
• Check and clean flame sensor if necessary
• Check for water leaks
• Check water pressure
• Check incoming gas pressure
• Check manifold gas pressure
• Check burner operation
• Check zone valves for each zone
• Make any recommendations to customer

Gas Furnaces:

• Clean air filter
• Tighten electrical connections
• Check incoming voltage
• Check amp draw of the fan motor
• Check amp draw of inducer motor
• Check blower wheel (extensive cleaning extra)
• Check for loose or frayed wires
• Lubricate motor
• Check for proper CFM
• Check limit operation
• Check gas condensate tubing and traps
• Check all pressure switches
• Check all venting and terminations
• Check igniter
• Check and clean flame sensor (if needed)
• Check visible area of heat exchanger
• On 80+ gas furnace clean heat exchanger
• Check pilot and thermocouple
• Check gas pressures - incoming
• Check gas pressures - manifold
• Check all safety controls
• Check burner operation
• Check heat exchanger temperature rise
• Inspect ductwork for leaks or problems
• Make any recommendations to customer